2019年手机中文字幕,久亚洲一线产区二线产区三线产,国产精品久久片

What is the most ideal way for winter heating of large-space industrial plant?

time：2023-11-01
hits：1503次
source：正弘奧能

Large space heating in winter has always been a problem in the industry. In the space of tall buildings, there are widespread problems such as large heating area, poor wall insulation capacity and high energy consumption. Therefore, in the choice of heating equipment, the following factors should be considered: energy saving, environmental protection, heating comfort and heating effect. 
 
Analysis and comparison of radiant heating and convective heating 
 
At present, according to the different nature of the use of buildings, the heating of general tall space buildings mainly uses radiation heating and convection heating. 
 
The traditional heating method of industrial plants is to use heat sources such as hot water boilers, steam boilers through pipelines and air handling units, heaters, radiators and other cooling equipment to heat the air in the plant, relying on air convection to achieve heating purposes. However, in the traditional convective heating system, due to the rise of hot air, a large amount of heat is consumed in the upper part of the tall building, and the lower working area is difficult to obtain enough heat, and the temperature distribution is uneven, which not only causes energy waste, but also poor thermal comfort. 
 
The heat in the radiation heating process is mainly concentrated in the middle and lower part of the room, which is more conducive to being absorbed and utilized by the human body, the temperature rise is faster, the thermal comfort is strong, the energy consumed in the air is less, the energy utilization rate is high, and the heating effect is good. Therefore, radiation heating can better reduce the influence of temperature gradient than the previous two traditional heating methods. 
 

	When the indoor air temperature is the same, radiant heat directly transfers heat to the heating object. The realistic temperature of radiant heating is 2~3℃ higher than that of convective heating. That is to say, under the condition that the indoor realistic temperature is the same, the indoor air temperature of radiant heating is 2~3℃ lower than that of heating, so the indoor heat consumption is small and the temperature difference between indoor and outdoor is small. The cold air permeability is also small, thus improving the indoor heating effect.


	 


	<img src="http://www.job00531.cn/Uploads/image/20231101/20231101102318_82548.jpg" alt="" /> 

 
The experiments show that the room temperature of 16℃ under the radiant heat condition is equivalent to the convection environment of 18~20℃. It is understood that if the room temperature is reduced by 1 ° C, about 10% of energy can be saved. 
 

	IMPRESIND gas radiant heating series promoted and sold by Beijing Leadway Power Co., Ltd. is an independent heating system, which can be installed on the roof or on the wall. The generator power of radiant heating is between 180 and 270KW, and the maximum length is 120 meters. The unit is an independent gas mounted heating device used in industrial plants, warehouses, hangars and other types of tall space places.


	 


	<img src="http://www.job00531.cn/Uploads/image/20231101/20231101101929_77958.jpg" alt="" /> 

 
Although the system has the same principle as the prefabricated radiation tube (gas radiation small tube equipment), the lower surface temperature, the special geometry expands the diversity of the configuration, the advanced combustion and flue circulation system, and the very low carbon monoxide and nitrogen oxide emissions make it very different from the latter, which is an energy-efficient and green heating equipment. It is the first choice of heating products for tall space buildings.

国产成人精品视频一区二区不卡_亚洲avav国产av综合av_国产盗摄XXXX视频XXXⅩ_放荡少妇深喉吞浓精_亚洲区色_伊人av影院

What is the most ideal way for winter heating of large-space industrial plant?